top of page

Technical Info

Tech Notes/Instructions/Videos/PDFs

TECH STREAM CALIBRATION

STEP 1: Plug in the OBDII to USB to both the vehicle and the computer.  Turn the key to the on position or push the start button twice without pressing the brake.  Open Tech Stream and click Connect to Vehicle.  (Top left)

techstream-image

STEP 2: Select the options that pertain to your vehicle. If connection isn’t successful after ~10 seconds turn ignition off for a moment then back on.

techstream-image

STEP 3: Click Occupant Detection (on the right) then click the arrow at the bottom.

techstream-image

STEP 4: Insure no codes are present and click utility (on the left).

techstream-image

STEP 5: Click zero point calibration and  green arrow (lower right).

techstream-image

STEP 6: Follow the prompts insuring the seat is in the proper position as described, exit when complete

techstream-image
techstream-image
techstream-image
techstream-image

STEP 7: Select Sensitivity Check and click the green arrow.

techstream-image

STEP 8: Follow the prompts exit when complete.

techstream-image
techstream-image
techstream-image
techstream-image
techstream-image
techstream-image

CALIBRATION COMPLETE

bottom of page